Simple question..

[MrBud]

I'm still new to micro BR,,,managed to record tracks 1-4 all volume/pan/and effects as i like,,,getting ready to bounce on to "12V2"

Is it just go to the start of song and hit play/record....?  And,pans/volume/effects remain as i had set them ?

Any help highly appreciated....

PS: At that point [post bounce], i can freely record on to v1,  without losing bounced tracks ? [as long as i don't record over v2 ..correct ? ] 
So,tracks 1-4 all open to record upon in v1 ...?

Sorry to sound so simplistic,,but it's a little confusing ...and i do not want to screw it up [again !] PS: Yes,did download manual,,,but person to person is easier to understand....Thank you.

[Oldrottenhead]

bounce to 12v2 then go back to normal setting and set all four tracks to v2.
tracks 1 and 2 is where your bounce is located, pan those tracks  full left and right for a stereo mix, tracks 3 and 4 are empty so you can add to them. when tracks 3 and 4 are used do same again but to 12v3 etc etc. i have been drinking but if you dont understand i'll say it all again in the morning english sober.

[Geir]

Is it just go to the start of song and hit play/record....? 

NO ... well, just be sure you're in bounce mode first !!!! Simultaneously press [EXIT] and
[UTILITY] several times to make the display indicate BOUNCE. Then you're good to go.

And,pans/volume/effects remain as i had set them ?

Indeed they will.

PS: At that point [post bounce], i can freely record on to v1,  without losing bounced tracks ? [as long as i don't record over v2 ..correct ? ] 
So,tracks 1-4 all open to record upon in v1 ...?

You're first four tracks were recorded on V1 ! The bounce you will put on T12V2. Then you should record your next two tracks on T3V2 and T4V2

Hope this helps .... I'll see if I can find a link that describes this better, with some illustrations and all

[Geir]

Here you'll find some useful info:

https://songcrafters.org/community/index.php?topic=3532.msg35695#msg35695

[launched]

The bounce you will put on T12V2. Then you should record your next two tracks on T3V2 and T4V2

Yes, great advice - Make sure you record to your bounce on blank tracks as not to overwrite your previous tracks. Your V1-4 cannot be reused because you might want to rebounce the recorded tracks again after you've recorded everything.

[MrBud]

First thank's to all for responding to my questions re: bouncing previously..

I now have very good mix so far,,,have bounced tracks 1-4 v1 onto v2 1-2
then had room to do vocal and bass on 3-4 v2...

So now, to open 2 last tracks [hopefully to finish this] should i move tracks 3-4 v2  to track 1-2 v3 ? or , to tracks 3-4 to v3 ?

Last question,,,that will leave open.... ?   Thanks so very much for your patience.....I promise to post it as soon as i can gather myself after all is done !    George [Mrbud]