got a brass saddled tele. My open B sounds like a sitar. This is not good. Any advice?
henwrench
Quote from: henwrench on January 14, 2010, 07:23:57 AMgot a brass saddled tele. My open B sounds like a sitar. This is not good. Any advice?
henwrench
Hmmm, that's strange. Don't know, maybe slip something under the string on the saddle to stifle it a bit, but that may plummet the tone. But first do a Indian Jhala tune ;D
You could try to raise the action up just a hair on that string only.
LG
If only the open string then it sounds like a nut problem - up your headstock end rather than down pickup end. The groove where your string sits may be worn. New one will only cost about $5-10. I've never replaced one though.
I think I'm with Migs on this one. Sounds like you need a new nut. If you want instructions on how to change it, let me know.
Issue solved. Twas the 'break angle' of the string over the saddle. Simply restrung thru back of the 'ashtray' rather than than thru the body. Job done!!
henwrench
Cheap fix, new lesson learned, playable guitar. That's a win.
Here's a fix for noisy or false overtones from a string.
Usually the odd ringing tones are caused by a worn or improperly cut string slot in either the bridge saddles or the nut. A poor breakover angle or, in the case of older instruments, a worn and rounded string slot. The breakover angle can be fixed by filing the slot. I use V shaped files for this work. Riffler files work fine for slotting for the small strings. Larger files will be needed for the wound strings.
The slot should be V-shaped, so the string contacts it at only two points. If the slot is rounded the string can roll around in it. Not good. False tones and frustration will occur.
If you are getting strange tones from a wound string the problem may be a slot that is just a bit too small for the string. The winding on the string can bind and cause this problem. Filing and slightly widening the slot will fix this problem. Be careful and work slowly. A few strokes of the file, then test the string for a proper fit. Repeat until you are satisfied with the results. A string should never contact the bottom of the slot. If it does, replace the saddle with a new one.
If you require luthier's tools, or any parts or finishes, a good site to visit is Stewart McDonald.
If they don't have it, it doesn't exist. And quick service as well. Ask them to send you their free catalog.
It will become your Christmas wish list very quickly.
http://www.stewmac.com
Gene
Quote from: Speed Demon on November 08, 2010, 04:52:55 AMIf you require luthier's tools, or any parts or finishes, a good site to visit is Stewart McDonald.
If they don't have it, it doesn't exist. And quick service as well. Ask them to send you their free catalog.
It will become your Christmas wish list very quickly.
http://www.stewmac.com
Gene
I bought a radius block from these guys, it arrived really quickly considering they had to post it to the UK. I now get the catalog posted to me regularly. I could spend thousands with them, but I'm married.
Good shizzle though.